I need to drill a hole for a soap dispenser in a cast iron sink, that has a porcelain enamel. What is the best way to do this without ruining the sink?
The 2nd post here has some instructions, but I’m not sure:
http://www.thestuccocompany.com/maintenance/Drilling-holes-in-my-kitchen-sink-121385-.htm
Related Blogs
- Related Blogs on Coated/cast
- Related Blogs on Drilling
I use non bio powder and clean the draw weekly but have a problem with the top of the draw unit and the chute. Any advice would be gratefully recieved.
The machine is used daily.
Related Blogs
Related Blogs
I love using foam hand soap at my bathroom and kitchen sinks. I currently have 2 plastic foam soap dispensers that I bought with the soap in it. When those ran out, I bought a big container of foam soap refill and keep filling the plastic dispensers. I thought it would be nice to have decorative foam soap dispensers instead of the generic plastic ones I’m using. So, I started searching in stores and I can’t find any specifically for foam soap. Everything I’m finding is for standard liquid hand soap, not foam soap. I tried putting a little foam soap into a standard liquid hand soap dispenser and it didn’t foam. Does anyone know where can I find decorative foam soap dispensers? I have found a couple plain foam soap dispensers online, but I would prefer to get something from a store so I can look at it.
Related Blogs
- Related Blogs on Decorative
Related Blogs
It could be a made up word. It could analogize something from sports, or politics, or religion. I suppose this word could also apply to the same situation at the faucet and the paper towel machine. I don’t have an answer, but I’m sure we’ve all experienced the wasted time hovering under the soap machine, only to realize you have to push or yank that sucker.
Related Blogs
picture shows spray on left side of sink, and soap dispenser on right. Can they be switched?
Related Blogs
Related Blogs
I took off the front panel, now i can’t get the soap dispenser arm to engage the arm on timer/ motor.
Related Blogs
I bought the PC hand soap dispenser, which you add liquid soap and water to. The pump makes a foamy lather for hand washing. The pump has recently begun getting stuck in the downward position. I can manually pull it back up after each push, but it’s getting annoying. Has anyone else had this problem with their PC pump? If so, what should I do? I haven’t had the pump very long… maybe 6 months, and I’m already using the back-up pump for the same problem I’m having now.
The Youtube
Related Blogs
I have a soap dispenser for my kitchen sink. I need to cut a 1 inch hole in the sink to install the dispencer. it is about 1/8 inch thick. How can i cut a hole in it?
Related Blogs
Related Blogs
I was thinking of replacing my soap dispenser in my kitchen sink with a water dispenser. Now with the hot water dispensers, like the Westbrass ones, you need a tank to be installed with the water dispenser.
With the cold water dispensers, what do they connect to? I can’t seem to find any kind of filtered tanks for that. Is there some kind of “splitter” for your regular water faucet?
For reference, I’m talking about these:http://www.westbrass.com/KA.htm#waterdis…
Related Blogs
The foaming dish and hand soap bottles can be refilled, but the pump sticks. It says on the label not to get it wet but that is nearly impossible.
Related Blogs
